What is the function of the red light indicator of the laser marking machine and how to adjust it?

Perhaps many customers who have actually operated the laser marking machine have some personal opinions on the red light marking operating system of the marking machine. The production of a laser marking machine must include the red light marking operating system, which is often referred to as red light debugging. However, there are many basic functions of red light debugging, which are extremely important for the precise positioning of laser marking machine marks.

    The effect of laser not disturbing red light mark red light debugging includes the following three points:

    ★, the red light can also be used as the focus point of the laser marking machine, that is to say the marking of the laser marking distance;

    ★, the red light debugging is used as the indicator light, which is used in the light path of the debugging resonator;

    ★, as the marking light for the precise positioning of laser marking of laser marking machine, according to the difference of laser marking software, it can be divided into laser marking center marking, laser marking pattern length and width range marking, and laser marking pattern as a whole Various labeling methods such as analog labeling;

Special attention is also paid to turning on the red light debugging of the laser marking machine, and the actual operation staff must be familiar with the machine and equipment. For example, the red light debugging of the general laser marking machine manufacturers is all in On the laser marking software.

    The red light control switch can be turned on or off by pressing the key F1 or the red light button on the marking interface for actual operation. If you only see the galvanometer moving and no red light comes out, then check it first and control the red light. Whether the light has a mechanical control switch that is not turned on, check whether the red light switch power supply is turned on, use a multimeter to check whether there is a 5V voltage between the two red and black bars of the red light indicator. If it is a 5V voltage without laser output, then What is certain is that the red light indicator must be replaced.